To Next PageTo Next Page
Need help?Do you have a question about the Tymetal Corp. TYM 2000 and is the answer not in the manual?
Defines CAUTION and WARNING notes for potential hazards and damage.
Important installation safety instructions and regulatory warnings.
Importance and procedure for installing an earth ground rod for operator safety.
Procedure for initial adjustment of the gate travel limit nuts.
Procedure for precision adjustment of the gate travel limits.
Setting current limits to detect obstructions and prevent entrapment.
Setting the maximum time the operator will run before stopping.
Restoring the controller to its original factory settings.
Overview of sensitivity adjustment for loop detectors.
Steps for setting sensitivity using the DEFLECTOMETER.
Steps for manually setting sensitivity levels without the DEFLECTOMETER.
How the detector diagnoses loop faults and indicates them.
Troubleshooting common issues with MGT transmitters.
How the operator responds to an open obstruction.
How the operator responds to a close obstruction.
How to reset the operator after an entrapment condition.
How a COMM LINK failure is indicated and its effect.
How MGT transmitter troubles are indicated and cleared.
How exceeding the maximum run time is indicated and cleared.
Contact information for technical support regarding gate operators.
Troubleshooting common causes for an operator failing to start.
Troubleshooting steps when the motor runs but the gate doesn't move.
Diagnosing issues when the motor sounds strained.
Troubleshooting limit switch timing issues.
Reasons why the gate stops unexpectedly without a visible obstruction.
Solutions for a gate that remains open when using automatic systems.
Key safety rules for operating and maintaining the automatic gate system.
How to use the manual disconnect lever to disengage the operator.
Information on UL 325 compliant obstruction sensing devices.
General| Brand | Tymetal Corp. |
|---|---|
| Model | TYM 2000 |
| Category | Gate Opener |
| Language | English |
