10
PAIRING
The Wireless Backup Camera is pre-paired with the Monitor, and it is set as rear camera as default. You
should see the following screen that shows the rear view if the Dash Monitor is powered and the Wireless
Backup Camera is fully charged.
If you can not see camera image showing on Dash Monitor, pair the Camera with the following steps:
1. Press and hold the Power Button under the
camera for 6 seconds, or until the LED ashes
Blue continuously. The camera will be turned
on and enter Pairing Mode for one minute.
2. Or press and hold the Power Button for 5
seconds to enter Pairing Mode if the camera
is already on.
3. On the Dash Monitor, tap
the Settings icon and then
tap Pair Camera to enter
the pairing screen. Tap Front/
Rear Camera - Click to pair.
Blue LED light
To Next Page
Loading...
Need help?
General
