14 U-Line 1000 Series Maintenance
Wire Shelf Removal/Installation
For ADA models equipped with wire racks, reposition the
shelves as follows:
Figure 1
1. Remove shelf retention clip.
2. Pull shelf out about 6"
(1)
, until back of shelf clears the
“hump” on the right-hand side.
3. Tilt up right-hand edge of shelf
(2)
.
4. Remove shelf from unit by pulling out
(3)
.
Insert the shelves as follows:
1. To move to a different position in the unit, insert shelf
at an angle, approximately 15-20°, over the rib in the
side of the unit where you want to place the shelf. The
shelf must be started into the unit at an angle to clear
the door.
2. Continue to slide the shelf into the unit at an angle
until it clears the door.
3. Lower the shelf and push it in completely.
Install shelf retention clip.
To Next Page
Loading...
