6. Insert the grille screws and tighten being careful not to overtighten.
7. Install the control knob by aligning the flat of the control knob with
the flat on the shaft. Push firmly.
WINE RACK REMOVAL/INSTALLATION
To remove the wine racks for cleaning:
1. Grasp the end of the wine rack,
sliding it out and up.
2. Clean wine rack with a damp
rag.
To insert the wine racks:
1. Position the wine rack above the
shelf channel where the rack is
to be inserted. (See Figure 19.)
2. Slide the rack on the channel at
an angle until the rack is in the
channel.
3. Continue sliding until the rack is
all the way into the Wine Captain
®
.
BULB REPLACEMENT
To replace the light bulb in your Wine Captain
®
:
1. Remove the light housing cover
by sliding the cover towards the
tab, swinging the end opposite of
the tab down and pulling down
and away (see Figure 20).
2. Replace bulb with genuine U-Line
replacement.
3. Replace the light housing cover by
inserting the tab FIRST and push-
ing up the other end. You should
hear a snap/click.
22
User’s Manual
T
A
B
2
3
1
UL305
Figure 20
UL302
Figure 19
30_10008_E_WC_UM 4/25/02 8:43 AM Page 22
To Next Page
Loading...
