PAGE 4 OF 12 0314 IH-161
π
CHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
1-800-295-5510
uline.com
• Always keep the sealing platform clean.
• Do not use water to clean the sealing platform.
• A short circuit will occur if the bottom teflon cloth
strip wears out. Each time you replace the heating
element or the top teflon cover, check the bottom
teflon tape for wear and damage.
• Only use ULINE replacement parts.
• A worn rubber pressure pad (under the handle) will
influence the quality of the seats. The rubber pad
should be periodically checked for uneven wear.
CAUTION! To provide continued protection
against risk of electric shock, connect to
properly grounded outlets only.
• If the bag seal is damaged or broken, it is because
the heating time is too long. Reset the timer knob to a
lower number.
• If the plastic bag sticks to the sealing arm, it was
because there was not enough cooling time. Keep
the arm down for a longer period of time after the
light turns off.
• It is okay to leave the unit plugged in. The unit is off
unless the sealing arm is down.
• Information regarding potential risks of fire, electric
shock, or injury to persons that are capable of
occurring due to use of the product. The instructions
shall caution the user to place the product and
connected cord so that it is not likely that the product
will be overturned.
• Information regarding the potential risks of electric
shock due to overfilling, the replacement of a lamp,
or cleaning the product without disconnecting the
power-supply cord.
• Instructions regarding the cleaning of the product,
including any necessity for disassembly (and
reassembly).
• Close supervision is required when this product is used
near children.
ADDITIONAL INFORMATION
To Next Page
Loading...
Need help?
General
