PAGE 1 OF 6 1021 IH-2932
1-800-295-5510
uline.com
UNLOCKING
Factory default code is 3. Press "3" and click OK.
Rotate knob to unlock and open door. Lock will
reengage after three seconds if not rotated.
LOCKING
Rotate knob counterclockwise to exact position.
CHANGING CODE
Insert old code and click OK twice. Enter new code
between one and 15 digits and click OK.
NOTE: System can be unlocked up to 500 times
when battery has low power.
NOTE: If the code is entered incorrectly three
times, alarm will sound for 60 seconds. Correct
code input will cancel alarm.
DIGITAL KEY CABINET
H-2932, H-4734, H-6265
H-7176, H-7766
BATTERY
OPERATION
FIRST USE
Each lock has a new battery installed at the factory.
White insulation slices interrupt the connection to
prevent power consumption during transport. When
first using lock, pull out the white insulation slices. Listen
for the click of the smart lock, which indicates lock has
started working.
REPLACING BATTERY
Remove the battery cover by pushing pin tool through
hole next to battery cover on side of lock. Remove
cover and insert new battery.
Para Español, vea páginas 3-4.
Pour le français, consulter les pages 5-6.
SOUND DESCRIPTION
Short Sound Effective Keypress
Long Sound Unlocking/Change Code Successful
Two Sounds Operation/Input Error
Three Sounds Low Battery
Alarm Three consecutive incorrect code inputs
To Next Page
Need help?
General
