U-Line H-7951 - User Manual

PAGE 1 OF 9 0321 IH-7951
H-7951
46" INGROUND
SQUARE PICNIC
TABLE
1-800-295-5510
uline.com
TOOLS NEEDED
Socket Wrench
PARTS
1/2" Socket Bit
14 mm Socket Bit
1/2" Wrench
14 mm Wrench
Bench Seat x 4
5/16" x 1½"
Bolt x 24
5/16" Nut x 24 3/8" Nut x 85/16" Wash e r x 48 3/8" Washer x 16
Tabletop x 1
3/8" x 5" Bolt x 8
Inground Mount Pole x 1
Bench Support Bracket x 4
ASSEMBLY
Figure 1
1. Verify all parts are present before beginning.
Hardware is located in a white box.
2. Flip tabletop upside down. Attach inground mount
pole to the tabletop using eight 5/16 x 1½" bolts,
sixteen 5/16" washers and eight 5/16" nuts.
(See Figure 1)
Para Español, vea páginas 4-6.
Pour le français, consulter les pages 7-9.

U-Line H-7951 Specifications

General

Brand	U-Line
Model	H-7951
Category	Outdoor Furnishing
Language	English

Summary

Tools Needed

Parts

Assembly Instructions

Verify Parts and Hardware

Verify all parts are present before beginning assembly. Hardware is located in a white box.

Attach Inground Mount Pole to Tabletop

Flip tabletop upside down. Attach inground mount pole to tabletop using eight 5/16 x 1/2" bolts and eight 5/16" nuts.

Attach Bench Support Brackets

Attach two bench support brackets to inground mount pole using four 3/8 x 5" bolts and four 3/8" nuts.

Repeat Bracket Attachment

Repeat the bracket attachment step with the remaining two bench support brackets.

Attach Benches to Brackets

Attach benches to the bench support brackets using four 5/16 x 11/2" bolts and four 5/16" nuts on each.

Dig Footing Hole

Dig a hole approximately 24" deep and 16" wide for the table footing.

Add Gravel and Position Table

Fill the bottom of the hole with gravel. Place the table in the hole ensuring the bench seat is 18" above ground.

Pour Concrete

Pour premixed concrete into the hole to secure the table until it hardens.