PAGE 10 OF 31 0124 IH-8041
TROUBLESHOOTING CONTINUED
OPERATING ISSUE CAUSES RECOMMENDATIONS
The machine leaves stripes of
wet floor.
Dust or debris on the floor is catching on
the squeegee blades.
Debris is trapped between the squeegee
blades.
The squeegee blades are worn.
Sweep the floor prior to using the
machine.
Clean out debris from the
squeegee blades.
Replace the squeegee blades.
The batteries do not provide
the nominal work time.
The battery charger is not working. See battery charging instructions.
The battery discharges too
fast during use, even though it
has been charged correctly.
The battery is new and does not deliver
100% of its expected capacity.
This is normal. New batteries
require a break-in period of
approximately 10 charging cycles.
Unplug unit and use as normal.
Charge after use.
ERROR CODE DISPLAY
ERROR CODE ERROR
Brush Button LED:
2 quick flashes / pause / 2 quick flashes.
Brush short circuit error.
Brush Button LED: 1 flash / pause/ 1 flash. Overcurrent error.
Fan Button LED:
2 quick flashes / pause / 2 quick flashes.
Suction short circuit error.
Fan Button LED: 1 flash / pause / 1 flash. Overcurrent error.
Brush Button LED: + Fan Button LED, synchronized flash /
pause / synchronized flash.
Electronic board
temperature error.
Brush Button LED:
4 quick flashes / pause / 4 quick flashes.
Brush thermal protector error.
Battery indicator yellow LED:
7 quick flashes / pause / 7 quick flashes.
Machine on with battery
charger powered error.
Battery indicator yellow LED:
5 quick flashes / pause / 5 quick flashes.
Excess battery voltage error.
To Next Page
Loading...
