PAGE 4 OF 31 0124 IH-8041
ASSEMBLY
NOTE: Battery must be fully charged before first
use.
ASSEMBLE SQUEEGEE
1. Tilt unit back and attach squeegee to scrubber by
inserting the black knobs into the notches on the
black bar. Turn knobs clockwise to tighten.
(See Figures 1 and 2)
2. Connect hose end to squeegee. (See Figure 3)
ASSEMBLE BRUSH
1. Install the brush by rotating it on counterclockwise.
Reposition the unit upright. (See Figure 4)
INSTALL FUSE
1. Locate fuse in plastic parts bag. Lift recovery tank
off unit to expose fuse connector. Connect fuse and
close connector. Replace recovery tank on unit and
place lid on top. (See Figures 5 and 6)
2. Connect hose to tank. (See Figure 7)
Figure 3
Figure 4
Figure 6
Figure 7
Figure 1 Figure 2
Figure 5
To Next Page
Loading...
