PAGE 1 OF 9 0617 TH-959
π H-959
POLYPROPYLENE
STRAPPING MACHINE
1-800-295-5510
uline.com
OPERATING ISSUE RECOMMENDATIONS
Strap jams while cutting and sealing.
Check if strap can be pulled out of the right side door. (See Figure 1)
1. Turn power OFF and open top cover. Check if strap is jammed
between press bar and front bar. (See Figure 2)
2. If strap is jammed between press bar and front bar:
a. Slide LS1 plate towards rear of machine until the plate and
separator come off.
b. Lift heater off the two screws.
c. Lift springs from press bar, front bar and rear bar post. Lift out
bars.
d. Wipe down bars and square holes.
e. Lubricate bars with light lubrication, such as WD-40®, and
reinsert bars.
f. Reattach springs to post. Put heater, LS1 plate and separator
back on, ensuring LS1 arm is put in separator slot.
g. Ensure the groove on the bottom right side of the LS1 plate is
positioned so the tip of the front bar goes into the groove when it
is raised up. (See Figure 3)
Strapping not heat sealing.
1. Make sure the heater blade surface is clean. Dirty blades
prevent strapping from sealing properly.
2. Use a Scotch-Brite™ pad to clean strap residue from top and
bottom of heater blade. Lift blade assembly to unhook from two
set screws to clean bottom of blade. (See Figure 4)
NOTE: Do not loosen set screws.
TROUBLESHOOTING
Para Español, vea páginas 4-6.
Pour le français, consulter les pages 7-9.
POWER
RESET
FEED
LENGTH
2
0
3
4
5
MAX
M
O
N
O
FF
To Next Page
Need help?
General
