U.S. Solid USS-DBS - Maintenance and Cleaning; Cleaning Guidelines

U.S. Solid®•USS-DBS Models • All Rights Reserved • Page 3
U.S. Solid® • 1200 E.55th Unit C, Cleveland, OH, 44103 • www.ussolid.com
U.S. Solid®•USS-DBS Models • All Rights Reserved • Page 8
U.S. Solid® • 1200 E.55th Unit C, Cleveland, OH, 44103 • www.ussolid.com
FEATURES
• Straing gauge technology
• Stainless steel pan
• Backlit LCD display
• Plastic draft shield
• Height-adjustable feet
• Taring
• Four dierent units of measure: g, lb, ct, oz
• Piece counting function
ALWAYS MAKE SURE YOU CALIBRATE YOUR SCALE BEFORE USING, AND NEVER TOUCH THE
INCLUDED WEIGHT WITH YOUR SKIN!
VI. Maintenance and Cleaning
To get the best results and for product longevity, be sure to follow the suggestions
below.
Note: All of the suggestions and guidelines mentioned below and throughout this
manual will only be eective with continuous and careful maintenance of the equip-
ment
• Follow all processes outlined in the manual
• Make the manual available to all users of the equipment
• Prevent the balance from any sudden movements or falls, as well as from direct
sunlight or air fl w. The balance is a precision instrument and must be handled
carefully.
• Balance must be plugged into a grounded electrical outlet and the socket should
be easily accessible to unplug in case of emergency
• Never unplug the balance by pulling on the wire, do so from the base
• Never use the balance in a wedged-in location, such as a shelf
• Never use other objects such as pens, pencils, etc. to press the buttons on the
control panel; use only your finger .
• Never place anything on the pan heavier than the maximum capacity of the bal-
ance, or the sensor could be damaged
• Do not submerge the balance, nor spill any liquids on it
• If any liquid does come into contact with the electrical parts of the balance,
immediately disconnect it and send it in for service to be checked and adjusted if
necessary
• Always use only original components and supplies. Other devices and parts may
appear similar, but can damage the equipment.
Cleaning
• Never use scourers or substances that can grate to clean metallic parts. This
include, but is not limited to, stainless steel, aluminum, coatings, etc.. These can
damage the balance and lead to early erosion of eectiveness of the balance.
• -Use a lint-free cloth, dampened with soapy water, that does not contain any
abrasive surfaces, nor corrosive materials
ATTENTION!! If equipment is not properly
cleaned and cared for, technical service will be
unable to fix or epair issues.