U.S. Solid USS-DBS - Panel Description; Installation; Choosing the Installation Location; Unpacking and Inspection

U.S. Solid®•USS-DBS Models • All Rights Reserved • Page 5
U.S. Solid® • 1200 E.55th Unit C, Cleveland, OH, 44103 • www.ussolid.com
U.S. Solid®•USS-DBS Models • All Rights Reserved • Page 6
U.S. Solid® • 1200 E.55th Unit C, Cleveland, OH, 44103 • www.ussolid.com
III. Panel Description
Panel Explanations
1. ON/OFF: Turns device on and o
2. UNIT: Select between ct, oz, lb, g
3. PCS: Piece counting mode
4. CAL: Calibration key
5. TARE/ZERO: Tare the balance
IV. Installation
Choosing the installation location
When analytical balances are used in routine lab or industrial measurement environ-
ments, the weighing speed will be much quicker, and the results more accurate. The
location should meet the following conditions:
1. Work room should be clean and dry
2. Balance should be placed on a solid, stable, plain fl t surface
3. Avoid locations in which the balance could be exposed to any of the follow-
ing:
a. Airfl w from air conditioners, fans, doors, or windows
b. Vibrations from surrounding or nearby equipment
c. Direct sunlight or radiation
4. Do not use the balance anywhere exposed to explosive, combustible, or
corrosive gases.
5. Do not use the balance in areas with high humidity or high levels of dust
6. When moving from a cooler to a warmer place, the accuracy and reliability of
the scale will be influen ed by the moisture condensation inside the balance.
In order to eliminate this influen e, it is best to leave the scale unplugged in
its new location for at least two hours before next use.
7. Avoid extreme temperatures or exposure to direct sunlight or air condition-
ers. Ideal working temperatures are between 5° C and 35° C (41°F and 95° F)
with tempature flu tuations of less than 1° C (1.8° F) per hour.
8. Keep the balance clean.
9. Do not leave material on the balance when not in use.
Unpacking and inspection
Check that all of the items indicated below are included in the package and that noth-
ing has been damaged:
• Balance
• Pan
• Power Cable
• External Calibration weight
• Draft Shield Pieces
In case the balance or any component is damaged during transport, tell your transpor-
tation agent immediately in order to process claims within the proper time frame.