How to correct small but constant error in airspeed or altitude on uAvionix AV-30-E Avionics Display?
To correct a small but constant error in airspeed or altitude on your uAvionix Avionics Display, set the trim adjustment in the Installation menu. See the Installation Manual for instructions.
What to do if the uAvionix AV-30-E Avionics Display shows “NO AP” flag when selecting an autopilot mode?
If the uAvionix Avionics Display shows “NO AP” when selecting an autopilot mode or while the AP is active, this means that the AV-30-E is either not communicating with the AV-APA, or that the AV-30-E does not have the information needed to perform the mode selected. If using an autopilot mode that uses GPS, make sure that the GPS has signal and an active flight plan.
Why does uAvionix Avionics Display generate nuisance alerts?
If your uAvionix Avionics Display generates nuisance alerts, ensure alerting limits are configured as desired in the Setup menu.
What to do if my uAvionix AV-30-E Avionics Display will not shut off?
If your uAvionix Avionics Display will not shut off, even if power is removed, ensure no pitot or static blockage or line kinks are present, which could be locking pressure and airspeed indication over 40 knots.
What to do if uAvionix AV-30-E Avionics Display unit flashes 'NO MAG'?
If your uAvionix Avionics Display unit flashes 'NO MAG' on the right side, complete the Mag Cal flight in section 12.2.3.
Why are audio alerts not heard over the audio system on my uAvionix AV-30-E?
If you cannot hear audio alerts over the audio system with your uAvionix Avionics Display, check the wiring and ensure alerts are enabled in the Setup menu. Also, ensure an unswitched input is available on the audio panel and verify the volume setting is sufficiently high in the Setup menu.
How to fix uAvionix AV-30-E DG drifting more than 30 degrees per hour?
To fix a uAvionix Avionics Display DG that drifts more than 30 degrees per hour, first make sure you are running the newest software. Also, complete the Gyro Cal and Mag Cal (if installed).
What to do if uAvionix Avionics Display shows 'NO GPS'?
If your uAvionix Avionics Display shows 'NO GPS', check that the GPS input is configured to match the connected GPS serial data type and speed.
What to do if my uAvionix AV-30-E Avionics Display shows 'NO DATA'?
If your uAvionix Avionics Display shows 'NO DATA', check the interface cables and pinouts.
Why is my uAvionix AV-30-E not powering on?
If your uAvionix Avionics Display is not powering on, you should first check the associated breakers and ensure that the aircraft battery is greater than 10 VDC. Also, check the wiring and pinouts.
General| Brand | uAvionix |
|---|---|
| Model | AV-30-E |
| Category | Avionics Display |
| Language | English |
To Next Page
