43
It is forbidden to:
- twist the strap, fold it lengthwise or allow its excessive slackness;
- iron the straps;
- fasten a child sitting on the knees of a passenger;
- make any changes in the belt design.
Safety belts must be replaced if they have scuff marks, damages or
after critical load impacts as a result of a trafc accident.
Replacement of safety belts must be performed only in the authorized
service shops of UAZ PJSC (addresses of the authorized service shops
are listed in the service book).
UAZ PJSC is not responsible for possible injures resulting from, for
example, trafc accidents, as well as for any other damage caused by
operation rules violation or unauthorized replacement of safety belts.
Driver's cabs are ventilated by means of a ventilation hatch in the
front middle, a hatch cover, bafes in the heater distributive pipes, as
well as rotating vent windows and down windows in cab doors. For more
efcient ventilation a cab heater fan can be used; turn it on by switch 10
(Fig. 3.3) with heating system valve 15 (Fig. 3.11) closed.
It is recommended to switch the cab (saloon) fan on when driving on
dusty roads. At that, the front ventilation hatch cover shall be open, and
the rotating vent windows and down windows in cab doors — closed.
Fresh air comes into passenger (medical) cab via rotating vent side
windows, as well as via a saloon heater shroud, if the fan is on by switch
11 (Fig. 3.3), and heat exchanger valve 15 (Fig. 3.11) is closed.
Extracting ventilation via louvers in the front and rear parts of the
bodyshell side panels is provided for the cargo compartment.
Cab heater with heat exchanger 13 (Fig. 3.11) is designated for driver's
cab and windshield heating.
Cab heater with heat exchanger 3 (Fig. 3.11) is used to heat passenger
(medical) cabs of UAZ-396295, UAZ-390995, and UAZ-220695 vehicles.
UAZ-390945 vehicle is tted with a heater depending on its conguration.
Switch on heaters by opening valve 15 (Fig. 3.11) of the heating
system using draw bar handle 16 (Fig. 3.1), and, if available, switch on
electric motor of 2+ heater pump (Fig. 3.11) by switch 11 (Fig. 3.3).
To Next Page
Loading...
Need help?
General
