ubbink RobotClean Accu - Maintenance and Troubleshooting; Tips and Hints; Trouble Shooting

1 Robotclean Accu Operating Instructions and Parts List
Tips and Hints
- The pool cleaner and lter insert should be cleaned after each use.
- The pH-value of the pool water should be between 7.0 and 7.4.
- Water temperature should be between 10°C and 32°C
Status Indicator
Switching ON Continuous light ashes blue
Switching OFF Continuous light ashes red
Automatic return Blue light ashes
Pause on reversing Rotes light ashes
Working cycle has ended The yellow light ashes three times and then shows constantly until the power supply is
switched o.
Low Voltage Yellow light ashes
Water inside Red light ashes
Pump protection mode Blue light ashes slightly
Trouble Shooting
Fault Cause Solution
The pool cleaner does not work and the control
light does not ash
Function for the protection of the battery
Charge the robot
Contact the customer service
The adapter control light does not work The adapter is damaged Contact the customer service.
The pool cleaner does not work and the yellow
control light ashes slowly
Low battery capacity Charge the battery
The pool cleaner does not work and the red control
light ashes slowly.
Fault in the pool cleaner Contact the service centre
The pool cleaner does not clean in all places.
Nozzle angle incorrect Adjust nozzle angle
Special pool shape Adjust nozzle to enlarge cleaning angle
The water circulation of your pool is switched on Switch o the lter pump
The pool cleaner does not work and the blue control
light ashes.
Function for the protection of the pump Re-start the pool cleaner
MAINTENANCE
For cleaning use a commercial care product.
Do not use any cleaning products containing solvents or scouring agents, or hard sponges, brushes etc.
Cleaning the lter unit
 CLEAN THE FILTER UNIT AFTER EACH CLEANING CYCLE
- Place the pool cleaner onto a level, clean surface and remove the upper housing by pressing the buttons on each side.
Einstellung 1: 0°/20° Standardeinstellung für die meisten Pools.
Einstellung 2: 0°/40° wenn der Poolreiniger das Becken nicht vollständig abdeckt.
Einstellung 3: 20°/20° für runde Becken.
Öffnen und Schließen des Gehäuses
Öffnen
Schließen
Montage der Bürste
1
Drücken Sie die Bürste in die an der
Außenseite des Gehäuseunterteiles
vorgesehenen Einkerbung
2
Stellen Sie sicher, dass die Bürste fest sitzt.
Demontage der Bürste
1
Drücken Sie die Bürste von der Innenseite
des Gehäuseunterteiles aus der Einkerbung
Manual RobotClean Accu new 1.indd 4 15.08.19 11:47