1
Robotclean Accu Operating Instructions and Parts List
Dear Customer,
Thank you for choosing our product to clean your pool entirely without cables or connection to the power.
We hope you enjoy your new pool cleaner when looking after your swimming pool in forthcoming years.
Take a few minutes before using your RobotClean Accu for the rst time and read the operating instructions carefully.
Scope of delivery
1 Pool RobotClean Accu
1 battery charger
1 pull cord 2.3 m
1 driving handle (red)
2 brushes
1 operating instruction booklet
DO NOT ENTER THE POOL WHEN THE CLEANER IS IN USE
Technical Data
List of Components
Ref.-Nr. Description Ref.-Nr. Description
1 Side Cover 9 Safety Screen
2 Floating Handle 10 Spring
3 Housing - Upper Part 11 Filter Element
4 Connecting Rod 1 12 Water Inlet Grid
5 Swing Flap 13 Housing - Lower Part
6 Connecting Rod 2 14 Wheel
7 Control Nozzle 15 Brush
8 Drive Unit 16 Pull Cord
IMPORTANT SAFETY NOTES
- Take note of all safety notes and instructions stated on the charging adapter and pool cleaner. Non-compliance can result in serious injury or damage to property.
- This appliance is suitable for cleaning water at temperatures between min. 5° C and a maximum of 45° C.
- When charging, the appliance may be connected only to an earthed AC 230 V shockproof socket
(residual current circuit breaker with a rated residual current of no more than 30 mA).
- The power supply for the charging adapter must be at least 3.5 metres away from the pool.
- The pool cleaner must be used only for cleaning private swimming pools. All other usage results in the immediate expiry of the warranty.
- The pool cleaner is not suitable for pools with a membrane thickness under 0.4 mm. The use of the pool cleaner below this lm thickness is at your own risk.
- The pool cleaner must not be used when there are people in the pool.
- The insulated drive unit and the charging adapter do not have components, which need servicing. Only expert technicians may open these parts.
The guarantee expires otherwise.
- During the cleaning process some lubricants may leak from the motor oil seal, which might result in slight contamination of the water.
LITHIUM BATTERY/BATTERY CHARGER
Input Voltage 100-240 VAC / 50-60 Hz
Output Voltage 12,6 V / 1,8 A
Battery Capacity 6600 mAh
Protection Class II
Protection Type IP20
Battery Life max. 2 hours
Battery Charging Time 5-6 hours
Operating Temperature (Charging Adapter) 0°C - 45°C
Storage Temperature (Charging Adapter) 20°C - 45°C
POOL ROBOT CLEAN ACCU
Input Voltage 12,6 VAC / 50-60 Hz, 50 Watt, 1.8 A
Protection Class III
Protection Type IPX8
Immersion Depth max. 2 m
Working Temperature 10°C - 35°C
Storage Temperature 20°C - 45°C
Safety System Yes (Overload Protection)
Type of Cleaning Floor
Cleaning Area ca. 50m
2
Cleaning Time max. 2 h
Speed approx. 16m/min
Filtration Grade 100 Micron
Suction Power approx. 10 m3/h
Manual RobotClean Accu new 1.indd 1 15.08.19 11:47
To Next Page
Loading...
