4746
05
MAINTENANCE
& CARE
Correct maintenance is important in keeping your 2×2
in good working order. Proper care means the bike will
always be ready to work when you are. Only you can decide
whether or not you should perform any given task – if you
are unsure please contact your service provider. Before you
start any maintenance, turn the bike o and remove the key.
Do not carry out any maintenance when the bike is
connected to a power supply.
Service check up
Contact your Ubco certified service provider for
a service check up after 6 weeks or 10 hours of
riding (whichever comes first). This check up is
required for warranty purposes.
Service provider: ...............................................................
Date serviced: .....................................................................
Signed: ...................................................................................
To keep your bike in the best condition possible,
the bike should also have a full service every
6 months. A small fee may apply.
A full listing of certified dealers is available online:
ubcobikes.com/support.
Cleaning
Do:
• Clean your 2×2 after each day of use, especially
when exposed to dirty terrain or salt water. If
you are using the 2×2 in a clean environment,
this may not be necessary.
• Before cleaning, turn the 2×2 o and remove
the key. Ensure all power outlets, including
the battery, have their rubber seals securely in
place. The battery should be plugged into the
bike while cleaning.
• Clean the bike with a low pressure hose and
soft automotive cleaning brush or sponge.
Do Not:
• Do not water blast or use a high pressure hose
on the bike.
• Do not submerge electrical parts – they are
protected from the rain and splashes, but
should not be left in water.
• Do not use cleaning products that are not
specifically designed for cars or motorcycles.
They may contain ingredients that could scratch
the finish or harm components of the 2×2.
To Next Page
Loading...
Need help?
General
