If your access point (wireless router or gateway) also supports
WPS, this method is recommended as it is a fast and secure means
of connection. If the access point does not have WPS, use the
UBH1706 web user interface to establish the wireless connection.
Instructions for both methods follow.
UBH1706-AA00 Quick Installation Guide
When both devices are WPS capable, you can join a secure WiFi
network without entering the network name and password.
1.
Switch the UBH1706 to Repeater (RP)
mode.
2.
Plug the UBH1706 into a power outlet.
Within a few minutes, you should see
the Power LED light up. If the power
LED does not light up, check that the
power outlet is working properly.
3.
Press the WPS button on the UBH1706
and hold for 2 seconds. The WPS LED
will start flashing.
4.
Within 2 minutes of pressing the
UBH1706 WPS button, press the WPS
button on the access point with which
you are connecting.
Using the WPS (Wi-Fi Protected Setup) Button
5.
If the WPS connection is successfully established, the UBH1706
will reboot. Upon completion of the reboot process, the
connection settings will be in effect.
•
When successfully connected to the access point, the 5G or
2.4G Signal LED will turn on.
•
If the UBH1706 WPS LED flashes , an error has occurred.
Wait for the WPS LED to turn off (about 2 minutes), and
repeat from step 3.
6.
After successfully connecting, you may move the UBH1706 to
the desired location. Check the Signal LED(s) for signal
strength, and choose a location with excellent reception.
Signal Strength Indicators
•
Steady Light: Excellent Reception
•
Flashing Light: Good Reception
•
Fast Flashing Light: Poor Reception
Congratulations! The setup is complete.
To Next Page
Loading...
General