Part Description Quantity Image
BB M6 Flat washer 38 PCS
CC M6X15 Bolt 18 PCS
DD M6X20 Bolt 20 PCS
Hardware Pack 2
Fig.7: Secure the top end of the slanted beam (H) to the top frame (G) with bolts (DD) and flat washers (BB).
Fig.8: Secure the slanted beam (H) to the lower connector 1 (E) with bolts (CC) and flat washers (BB).
Fig.9: Secure the middle beam (I) to the top beams (G) with bolts (DD) and flat washers (BB).
Fig.10: Secure the lower end of the middle beam (I) the lower connector 2 (F) with bolts (CC) and flat washers (BB).
Fig.4: Secure the assembled long beam 1 to the big panels (A1 and A2) with bolts (CC) and flat washers (BB). Repeat this step to
secure the short beam (D) to the small panels (B1 and B2).
Fig.5: Secure the lower connector 2 (F) and short netting tube (U) to the short beam (D) with bolts (CC) and flat washers (BB).
Fig.6: Secure the long netting tubes (T) to the long beams (C1 and C2) with bolts (CC) and flat washers (BB). Repeat this step to
secure the short netting tubes.
To Next Page
Loading...
