Need help?Do you have a question about the Ubiquiti NanoBridge M NB-2G18-HP and is the answer not in the manual?
General| Frequency Range | 2.4 - 2.5 GHz |
|---|---|
| Gain | 18 dBi |
| Polarization | Dual Linear |
| Max Input Power | 30 dBm |
| VSWR | 1.5:1 |
| Cross-Pol Isolation | 25 dB |
| Power Supply | 24V |
| Max. Power Consumption | 8W |
| Wind Survival | 200 km/h |
| Mounting | Pole Mount |
| Operating Temperature | -30 to 75 °C |
| Enclosure | UV-resistant plastic |
Lists the necessary tools and cabling requirements for device installation.
Attaches the dish bracket and rear housing to the dish reflector.
Inserts the antenna feed and connects the Ethernet cable to the device.
Secures the device to a pole using the pole clamp and U-bolt.
Guides through accessing the airOS configuration interface and logging in.
To Next Page