Need help?Do you have a question about the Ubiquiti UniFi G3 and is the answer not in the manual?
General| Video Compression | H.264 |
|---|---|
| Maximum Frame Rate | 30 FPS |
| Max. Power Consumption | 4W |
| Networking Interface | 10/100 Ethernet |
| Night Mode | Yes (IR LEDs) |
| Resolution | 1920 x 1080 (1080p) |
| Image Settings | Brightness, Contrast, Saturation, Sharpness |
| Microphone | Built-in |
| Power Method | 802.3af PoE |
| Mounting | Wall |
| Minimum Illumination | 0 Lux with IR |
| Sensor | 1/3" |
Instructions to remove the sun visor and accessory port cover from the UVC-G3.
Guides attaching the LED Ring to the camera front until it locks.
Instructs to insert the Accessory Connector into the accessory port until it locks.
Details tightening screws under the LED Ring to secure the UVC-G3-LED.
Steps to enable external IR LEDs via UniFi Video software interface.
Final step to save the enabled external accessory setting in the camera UI.
Instructions to access the camera UI using Ubiquiti Device Discovery Tool.
Checking the box to enable the external accessory in the camera settings.
Saving the configuration changes made in the camera UI.
To Next Page