To Next PageTo Next Page
Need help?Do you have a question about the Ubiquiti UVC-G3-BULLET and is the answer not in the manual?
General| Weather Resistance | IP67 |
|---|---|
| Power Supply | PoE (802.3af) |
| Sensor | 1/2.7" CMOS |
| Video Compression | H.264 |
| Max. Frame Rate | 30 FPS |
| Networking Interface | 10/100 Ethernet |
| Max. Power Consumption | 4W |
| Certifications | CE, FCC, IC |
| Resolution | 1920 x 1080 |
| Night Vision | Yes, with IR LEDs |
| Image Settings | Brightness, Contrast, Saturation, Sharpness |
| Power Method | 802.3af PoE |
| Mounting | Wall, Ceiling |
10/100 RJ45 port connects to an 802.3af PoE switch for PoE power and data.
To reset to factory defaults, press and hold the Reset button for more than 10 seconds while the camera is powered on.
Instructions for mounting the camera to a wall or ceiling using provided hardware.
Steps for fine-tuning the camera's field of view after installation.
Details on FCC rules and conditions for device operation and interference.
Information regarding Industry Canada's compliance standards for the device.
Compliance information for Australia and New Zealand, including CISPR 32.
Indicates product compliance with all applicable European directives.
Statement regarding Waste Electrical and Electronic Equipment compliance.
Official statement confirming the product meets relevant regulatory standards.
Links to additional resources and documentation for the product.
