NINA-W1 series - User Manual
NINA-W10 header
Mandatory:
o SWD
o ESP_BOOT (GPIO27)
Additionally recommended:
o RESET_N
2.4 Updating u-connectXpress software with s-center
The u-connectXpress software, flashed into NINA-W13/W15 modules prior to delivery, is used to
validate the hardware, bootloader, and the binary image. The u-connectXpress software runs only on
validated hardware.
Updates of the u-connectXpress software is available for download from www.u-blox.com. The
software is delivered in a zip container file, for example, NINA-W1xX_SW1.0.0.zip.
To upload the latest u-connectXpress software to the module:
1. Download and unpack the zip container, NINA-W1xX_SW1.0.0.zip, to your Windows
workstation.
2. Open the s-center client software.
3. From the client, navigate to the .json file in the unpacked u-connect archive and select
Update. The s-center handles the download using information contained in the *.json file
without any further interaction is needed from the user. See also Figure 5.
Figure 5: Software Update using s-center
☞ Secure boot functionality is supported in u-connect v4.7 and above.
Updating To manually start the download using a software without using s-center, enter the
following AT commands to start updating the NINA-W13/W15 u-connectXpress:
AT+UFWUPD=<mode>,<baud>,<image id>,<image size>,<base64 encoded signature>,<image
name>,<flags>
Sample parameters that can be used while doing the flash update is provided below:
AT+UFWUPD=0,115200,0,651840,jzlRIkg37ir/pVpDKVrPot2ZdsaNvUtSYP2pDAUVJc7iQI9yzIo8V
Fv8C1olP/9I4UJ4WmgC5oRay4AC0V8jRJSFFX/wop6x/sBJGOeDEu7yC/s0+Oj7CLs4TzNbiRqK0zLwKR
iHohgVyzWqhwKFpmcxcDXphjkCTIvpffY8TwDLzkowuuD59R+sQCueJtBHBg9KDB3TOs8bsXLaVtT2x1r
LfMg8/pb+BPQEK9NcNB4hbp693ATivYE3cmxzWykIjEje819SIRGhHFt0wAsqh7WFgSJYNgDi5cLdOYz+
r1+j7+l4RqrMl/A/QYyWS9z0Q15QcJ3GlAJlXYa5v/ISjA==,nina-w1-debug,rwx
To Next Page
Loading...
