AeroCut X / XPro SERVICE MANUAL
97
9.3 CPU board
・ If any changes are made to the program content, we will send the data to you most likely
by e-mail.
・ The data format will look like “AeroCut_X_V100.hex” with a file extension of “.hex” .
・ The figure “100” refers to a version, which means Version 1.00.
・ Save this data in a folder of your choice in your computer and upgrade the version as
follows. (The procedure below is for WINDOWS XP)
① Remove the front cover and then the electrical component cover.
② Connect the accessory of USB cable with Program writer.
③ Connect the connector of Program writer to CN7 on the CPU board.
To Next Page
Loading...
