Need help?Do you have a question about the UEi DL589 and is the answer not in the manual?
General| Brand | UEi |
|---|---|
| Model | DL589 |
| Category | Test Equipment |
| Language | English |
Crucial safety guidelines, warnings, and precautions for safe operation and to prevent injury or damage.
Details the functions of the selector dial, select button, range button, and min/max/avg/peak button.
Instructions for setting up and performing Low Z (Low Impedance) measurements on the DL589.
Procedures and safety notes for measuring AC and DC current using the clamp jaw.
How to use the Non-Contact Voltage (NCV) feature and interpret its alerts.
Instructions for measuring AC and DC microamps using test leads, including accuracy.
Step-by-step guide for performing digital field temperature calibration on the DL589 meter.
How to perform temperature measurements using K-type probes and select units (°F/°C).
Steps for checking circuit continuity, including buzzer indication and safety warnings.
Guide to measuring resistance values up to 60MΩ, including accuracy and warnings.
How to measure capacitance values, including safety warnings about discharging capacitors.
How to perform a diode test, interpret forward/reverse bias readings, and identify good/bad diodes.
Instructions for measuring AC and DC voltages, including high voltage alerts and safety.
Procedures for measuring frequency (Hz) and duty cycle using the meter.
Steps to capture and measure the starting current (inrush) of motors like compressors.
How to zero the DC Amps reading for accurate offset monitoring and measurements.
Important information regarding test lead category ratings, proper usage, and replacement guidelines.
Step-by-step instructions for safely replacing the batteries in the DL589 meter.
To Next Page
