Why is my UFESA Iron not producing steam?
Your UFESA Iron may not be producing steam because the boiler is either not switched on or is empty. Ensure the boiler switch is in the 'on' position and that the water tank is filled. Also, check that the steam regulator isn't set to the minimum position; increase the steam flow by adjusting the steam control.
What to do if water flows through the holes on the sole plate of my UFESA Iron?
If water flows through the holes on the sole plate of your UFESA Iron, it could be due to using the steam function before the iron has reached the correct temperature. Try reducing the steam flow when ironing at low temperatures using the variable steam control. Alternatively, the water might be condensing inside the pipes because steam is being used for the first time or hasn't been used for a while. Point the iron away from the ironing area and press the steam release button until steam is produced.
Why is my UFESA Iron not heating up?
If your UFESA Iron isn't heating up, first, make sure the main power button is switched on by setting the iron button to the 'on' position. Also, check that the temperature control knob isn't set to the 'min' position; adjust it to your desired setting.
What to do if my UFESA Iron begins to smoke when switched on?
If your UFESA Iron smokes when first used, this is normal. Certain components may have been lightly greased at the factory, and the smoke will stop after a short while. If it occurs during later use, the soleplate may be soiled, so clean it according to the cleaning instructions.
How to clean dirt coming out through the sole plate of my UFESA Iron?
If dirt comes out through the sole plate of your UFESA Iron, it could be due to a build-up of scale or minerals in the boiler. Clean the boiler using a mix of 50% tap water and 50% distilled or demineralized water. If the tap water is very hard, use a 1:2 ratio of tap water to distilled water. It could also be caused by using chemical products or additives. In this case, clean the sole plate with a damp cloth and never add products to the boiler.
What to do if the ironed garment turns dark and sticks to the soleplate of my UFESA Iron?
If the ironed garment turns dark and/or sticks to the soleplate of your UFESA Iron, the selected temperature is likely too high and has damaged the garment. Select a suitable temperature for the material and clean the sole plate with a damp cloth.
Why is my UFESA steam generator not coming on?
If the steam generator of your UFESA Iron isn't coming on, there might be a connection problem. Check the mains cable, the plug, and the socket. Also, ensure that the main power button is switched on by setting the buttons for both the iron and boiler to the 'on' position.
Why does the soleplate of my UFESA Iron turn brown?
The soleplate turning brown is a regular consequence of usage. Clean the soleplate regularly with a damp cloth.
Why am I experiencing loss of pressure during ironing with my UFESA Iron?
Loss of pressure during ironing with your UFESA Iron may occur if the steam release button is activated for an extended period. Use the steam release button with intervals to improve ironing results, as the textiles will dry and stay smooth better.
General| Type | Steam Iron |
|---|---|
| Soleplate Material | Ceramic |
| Power | 2400 W |
| Anti-Drip System | Yes |
| Anti-Calc System | Yes |
| Self-Cleaning | Yes |
| Weight | 1.2 kg |
To Next Page
