UFESA PV1555 - User Manual

Questions and Answers

S
Shannon BoothAug 13, 2025
How to fix UFESA Iron when steam doesn't come out?
- C
  Casey GarrettAug 13, 2025
  If steam isn't coming out of your UFESA Iron, consider these potential causes: 1. Check if the steam regulator is in a closed position and select the temperature corresponding to the steam regulator positions “COTTON” and “LINEN.” 2. Verify that the temperature regulator isn't set too low; adjust it to a steam position (1, 2, or 3). 3. Ensure there is water in the tank and refill if necessary. 4. If the mechanism is obstructed, carefully remove the needle and clean it. If the issue persists, further assistance is needed.
C
Christian MarshallAug 17, 2025
What to do if water comes out with steam from UFESA Iron?
- J
  Julie SmithAug 17, 2025
  If water is coming out with the steam from your UFESA Iron, it could be due to these reasons: 1. The temperature regulator might be in a very low position. Select the temperature corresponding to the positions “COTTON” and “LINEN.” 2. The steam regulator might be in a very high position with a low temperature. Turn the steam regulator to a much lower position (“1”).
R
Robert GonzalezAug 20, 2025
Why UFESA Iron doesn't heat up?
- J
  John RamirezAug 20, 2025
  Your UFESA Iron might not be heating up due to a couple of reasons. First, check if the temperature control is set to a very low position and turn it to a higher setting. Second, ensure that there is a proper mains supply by testing another appliance in the same socket or plugging the iron into a different socket.
C
christinebarrettAug 25, 2025
Why do clothes stick to my UFESA Iron?
- E
  ethompsonAug 25, 2025
  If clothes are sticking to your UFESA Iron, it's likely because the temperature is set too high. Try selecting a much lower temperature.
O
Olivia WagnerAug 28, 2025
Why UFESA Iron leaks water before turning on?
- A
  Alison RodriguezAug 28, 2025
  If water leaks from the soleplate of your UFESA Iron before you even turn it on, it's likely that the steam regulator isn't properly closed. Make sure to place the steam regulator in position “0,” and remember to empty the tank after you've finished ironing.
R
robertshepardSep 1, 2025
Why does my UFESA Iron turn off automatically?
- P
  pcoleSep 1, 2025
  The display light on your UFESA Iron might be flashing, and the position “OFF” might be selected because the auto shut-off function has been enabled. To resolve this, gently move the iron about.
B
Brian MillerSep 4, 2025
Why UFESA Iron spray doesn't work?
- L
  Leslie HensonSep 4, 2025
  If the spray function on your UFESA Iron isn't working, the possible cause is that there is no water in the tank. Fill the tank.
K
kimberlyoneillSep 8, 2025
Why does UFESA Iron smoke when first used?
- T
  Tony HansenSep 8, 2025
  If you notice smoke coming from your UFESA Iron when connecting it for the first time, don't worry. This is due to the lubrication of some of the inner parts and will disappear shortly after the first use.