12 13
BEFORE USE
IGNITION BATTERY
1. Install one AA battery for the electronic ignition located inside of the unit (battery not included). Unscrew igniter cap
counterclockwise, insert battery with positive side facing out, then tighten igniter cap back on (make sure the battery is
installed the proper direction). [Figure 1]
CHARGING THE AUDIO BATTERY
1. Before using your Ukiah Co. audio system, fully charge the battery by plugging the charging cable provided into the
charging port on the unit. [Figure 2]
• The LED INDICATOR on the charger will turn RED when the battery is charging.
• The LED INDICATOR will turn GREEN when the battery is fully charged.
The battery will run for up to 20 hours on a single charge. The unit can be operated while connected to the charger.
The internal battery powers the audio system only and is not needed for “Fire Only” mode.
WARNING — Charge the battery by using only the original charging cable supplied. Using another charging cable
may harm the battery.
LAVA ROCK/GLASS MEDIA
1. Open the bag containing the decorative glass or lava rock and carefully place in the burner tray, making sure not
to cover the screen that protects the ignition system or the holes of the burner. If the burner holes are covered, the
ames will not react to music and sound as intended. Replace magnetic lid if applicable to keep media contained for
transportation.
[Figure 1] - Install one AA battery. [Figure 2] - Battery charger input.
OPERATIONAL NOTES
1. DO NOT move the unit for at least 60 minutes after use to allow for cooling.
2. Allow the burner and glass crystals or lava rock to cool completely before touching.
3. Glass crystals or lava rock may be sharp. Before handling, make certain they have cooled
completely and handle them wearing protective gloves to prevent injury.
LIGHTING SAFETY
FOR YOUR SAFETY, READ BEFORE LIGHTING
• Make sure you are familiar with the owner’s manual and you understand all precautions noted.
• Before operating, smell around the appliance and next to the ground for gas odors because some gases are heavier
than air and may settle on the ground.
• Use only your hand to turn the gas control valve. Never use tools. If the valve will not turn (that is, without the use of a
tool), do not try to repair it. Call a qualied service technician.
• Do not use the appliance if any part has been submerged in water. Immediately call a qualied service technician to
inspect the unit and to replace any part of the control system and any gas control that has been under water.
• Make sure the igniter batteries have been installed properly. The igniter will not operate otherwise.
• Inspect hoses to make sure there are no kinks in them and check for leaks.
• After connecting the gas line and checking for leaks, the unit is ready to be lit. Upon the initial use, a small amount of
air will be in the lines. When rst lighting the burner, it will take a few seconds for the lines to purge themselves of this
air.
• Once purging is complete, the burner will light and operate as indicated in the instruction manual. Subsequent
lighting of the unit will not require purging unless the gas supply has been disconnected.
WARNING: Read and follow the safety and lighting instructions in this manual and on the labels on the appliance.
IMPROPER SETUP OR USE COULD RESULT IN A FIRE OR EXPLOSION RESULTING IN PROPERTY DAMAGE, INJURY OR
LOSS OF LIFE.
To Next Page
Loading...