Why is the burner flame low on my UKIAH TK-1006-T?
A low burner flame on your UKIAH Stereo System could be due to several reasons: * Low gas pressure: Turn the cylinder valve OFF and replace the cylinder. * Low outdoor temperature: If the outdoor temperature is less than 40ºF and the tank is less than 1/4 full, use a full cylinder. * Control knob: Ensure the control knob is fully ON and check the burner and orifices for any blockage.
What to do if my UKIAH Stereo System burner won’t light?
If the burner on your UKIAH Stereo System won’t light, it could be due to: * A frosted propane cylinder: Wait until the propane cylinder warms up and becomes unfrosted. * A blockage in the orifice: Clear the blockage. * The control knob: Ensure the control knob is in the ON position.
How to fix carbon build-up and thick black smoke from UKIAH TK-1006-T?
Carbon build-up and thick black smoke from your UKIAH Stereo System can be caused by: * Blockage in burner holes: Remove any blockage from the burner holes. * Kinked regulator hose: Straighten the regulator hose to remove all bends or kinks.
How to fix a burner that won’t light on UKIAH Stereo System?
If the burner on your UKIAH Stereo System won’t light, there are a few potential causes. The propane cylinder might be frosted over; if this is the case, wait until it warms up and becomes unfrosted. Alternatively, there could be a blockage in the orifice, which would need to be cleared. Finally, make sure the control knob is turned to the ON position.
What to do if there is carbon build-up and thick black smoke coming from my UKIAH Stereo System?
Carbon build-up and thick black smoke from your UKIAH Stereo System can be caused by a blockage in the burner holes; if this is the case, remove the blockage. It can also be caused by a kinked regulator hose; straighten the hose to remove any bends or kinks.
General| Brand | UKIAH |
|---|---|
| Model | TK-1006-T |
| Category | Stereo System |
| Language | English |
To Next Page
