7. The battery pack will reach optimum performance
after being cycled 5 times during normal usage.
There is no need to run the batteries down completely
before recharging. Normal usage is the best method
of discharging and recharging the batteries.
ASSEMBLY
!
Fig.2
!
Fig.3
ASSEMBLING THE BLOWER TUBE (Fig. 2 &
Fig. 3)
1. Fit the Blower Tube to the motor housing as
shown in Fig 2. Check the Blower Tube is firmly
secured.
2. Disassembling the Blower Tube, you can separate
the tube.(Fig. 3) Cocked up the next part of the
extension Down Blower Tube⑧, so that you can
separate the Down Blower Tube.(Fig. 3) Do not
try to separate the tubes by force or by using
tools.
!
Fig.4
ASSEMBLY FUNCTION OF SWIVEL
HEAD(Fig. 4)
Hold the handle ② tightly. Slide the locking press
button ⑤ up and then turn the work head to the
desired position. Release the locking press button ⑤
again and check whether the work head is locked in
place.
Note:The work head can be locked in five
positions(0°、18°、36°).
OPERATION
! WARNING! The charger and battery pack
are specially designed to work together so do not
attempt to use any other devices. Never insert or
allow metallic objects into your charger or battery
pack connections because of an electrical failure and
hazard will occur.
1. BEFORE USING YOUR CORDLESS
BLOWER
You must charge once before use.
The battery charger supplied is matched to the Li-ion
battery installed in the machine.
Do not use another battery charger.
2. CHARGING YOUR BATTERY PACK
The Li-ion battery is protected against deep
To Next Page
Loading...