ϭϮ
Abnormal sounds or vibrations The mounting brackets are not
properly installed on the
vehicle, or the device
mounting screws are not
sufficiently tightened
Check that the mounting bracket is
tight and tighten the device
mounting screws
The rubber stopper on the
bottom of the indoor unit is
missing, or is not pressed
enough
Water is leaking from
tthe indoor unit
Check or replace the rubber stopper
The device is at an angle
The device must be mounted
horizontally (maximum angle
<3°C
The appliance emits a
relatedodor
There is a serious problem Switch off the device
immediately and contact the
dealer
8. Maintenance
Cleaning
Caution: Unplug the power cord before cleaning the product.
For Cleaning the Outside:
Wipe the outside with a damp cloth. They dry the device thoroughly with a dry cloth. Do not allow
water or detergent to enter the machine. Do not clean the air conditioner with an aggressive cleaning
agent and/or petrol.
Clean Filter：
It is important to regularly remove the dust from the filter. Remove the filter as shown in the picture
below:
Clean the filter with tap water and/or a vacuum cleaner to remove any dirt from the filter.
Make sure the filter has dried before putting it back in the air conditioner.
Do not use water hotter than 40°C for cleaning and do not expose the filter to the sun.
To Next Page
Loading...