3. To remove the probe, pull the silver latch. (always remove the probe connector to the right first). DO
NOT let go of the silver latch until the connector is removed.
II. CONNECTING TWO (2) PROBES
To use two (2) probe only, connections A and C (yes, NOT B) will be used for the
first probe, then connections B and D will be used for the second probe.
1. Take any of the probe connector for the first probe and aim it towards Socket A of the probe
connections. Insert the probe connectors at an angle as shown below
2. Insert the other connector of the first probe to Socket C then turn both connectors towards the right
until you hear a click.
15
To Next Page
Loading...
Need help?
General
