NOT match. The voltage rating is marked on the label above the AC Receptacle (see
Figure 1).
b. Make sure the matching wall outlet receptacle is properly wired and earth-
grounded.
c. Never
use a 2-wire extension cords or a 2-wire NON-grounding types of multiple-
outlet receptacle strips.
d. Do not place containers holding any liquid on or near the front panel. The liquid can
potentially cause major damage on the electrical or mechanical components of the
device.
e. The POWER ON/OFF switch should ALWAYS be at OFF position when the device is
not in use.
Safety Against Risk of Fire
a. Fuses protect certain electrical circuits within this device against over-current
conditions. For continued protection against the risk of fire, replace the fuse only with
the same type and rating specified in this Instruction Manual (Refer EPulse Elite
Specification section).
b. Keep any materials capable of developing flammable or explosive vapors away from
the device while it is in operation (pulsing).
Mechanical Safety
a. Use only probes and accessories designed for use on this device.
b. Do not lift or move the device while using or pulsing.
c. NEVER use the device where wet weather may have contact with the device.
d. To clean the air intake and exhaust fans blow them with air or use a soft brush.
e. NEVER attempt to hold or remove the probe connectors while in use or pulsing.
f. NEVER attempt to open the control panel of the device.
6
To Next Page
Loading...
Need help?
General
