ERROR 6Self test failedDisconnect the device from the vehicle and the mains.
Then start the charging process again. If the error
should occur again, send the charger to the dealer
for repair.
ERROR 7Under voltage
(input voltage below 180 V
for 5 sec.)
Autorecovery of the charging process if the voltage
increases to over 190 V within 5 seconds.
ERROR 8Over Voltage
(input voltage is over 275 V
for 5 seconds)
Automatic restart of the charging process if the
voltage decreases to below 265 V within 5 seconds.
ERROR 9Relay contact errorDisconnect the device from the car and the mains.
Then start the charging process again.
ERROR 10Internal component error
(relay)
Disconnect the device from the vehicle and the mains.
Send the charger to the dealer for repair.
ERROR 11The charging cable
temperature is too high
(over 80°C)
Automatic restart of the charging process if the cable
temperature falls below 70°C.
ERROR 13PE test failedCheck protective conductor and PE cable.
ERROR 14CP voltage is incorrectDisconnect the device from the vehicle.
Then start the charging process again.
ERROR 15Short circuit cable
(CP or PE)
Disconnect the device from the vehicle.
Then start the charging process again.
ERROR 16Phase errorDisconnect the device from the vehicle and the
mains. Check all connections. Then start the charging
process again.
ERROR 17Loss of phaseDisconnect the device from the vehicle and the
mains. Check all connections. Then start the charging
process again.
ERROR 19RS485 Master errorOnly one device can be set as the Master.
ERROR 20RS485 Slave error
Connection with the Master
charger is lost.
Check the RS485 cable and make sure that the
Master charger is switched on.
ERROR 21RS485 address errorCheck setting It is possible that the PCB needs to be
replaced.
ERROR 22Check voltageDisconnect the device from the car and the mains.
Then start the charging process again. If the error
should occur again, send the charger to the dealer
for repair.
To Next Page