16
GB/IE/NI
an open position and pull the connecting valve
4
off the valve adapter
(refit the valve cap onto the inflatable item if necessary).
PLEASE NOTE: When disconnecting the connecting valve
4
, air can
escape from the valve on the inflatable item. Ensure that you remove the
connecting valve
4
as quickly as possible.
Pumping up the inflatable item
PLEASE NOTE: When the Mini-Compressor
1
is used for a long period of
time, the vehicle engine must be kept running in order to prevent the vehicle
battery from being drained meaning that the vehicle will no longer start.
Connect the connecting valve
4
of the Mini-Compressor
1
to the inflatable
item which you want to inflate. To do so, please proceed as described in the
previous section.
Switch the integrated compressor unit on by pressing the On/Off switch for
the compressor
10
.
The compressor will start and pump up the inflatable item.
You can switch off the compressor at any time by pressing the On/Off switch
for the compressor
10
again.
Disconnect the inflatable item from the connecting valve
4
as described in
the previous section.
ATTENTION: During operation, the compressed air connections and
the hose will become hot. Make sure that you do not come into contact with it
during operation to avoid suffering burns. At the end of the job, wait for at least
10minutes before you touch the compressed air hose.
PLEASE NOTE: The pressure gauge with pressure display
2
of the Mini-Compressor
1
is not trade-approved. After pumping up inflatable items where the wrong pressure
could be dangerous (e.g. bicycle tyres), always check the pressure at a service point
with a trade-approved device. Check the pressure of the inflatable item there.
Tips for use
The device is not intended for continuous operation. The device was designed to
create air pressure – not an air flow. Please do not use the device for more than
60 minutes at a time, to avoid overheating and damage to the device. Then let the
device cool down for at least 15 minutes. We recommend first filling a large-volume
item with air, in order to then generate the required pressure with the device.
451293_2401_Mini-Kompressor_LB6_content.indb 16451293_2401_Mini-Kompressor_LB6_content.indb 16 09.04.2024 11:28:1209.04.2024 11:28:12
To Next Page
Loading...
