Need help?Do you have a question about the Ultimate T2-5001 and is the answer not in the manual?
Introduces the new amplifier series, highlighting performance, budget, style, and thanking customers for their purchase.
Warns about high power, potential hearing loss from loud music, and risks of misuse or improper installation.
Details MOSFET technology, surface mount components, load testing, and amplifier characteristics for optimal sound.
Lists features for T2-602 and T2-604 models: Class AB, 2-ohm stable, MOSFET power supply, illumination, frequency response, and protection.
Lists features for T2-5001: Class D, 2-ohm stable, MOSFET power supply, dual summing, filters, frequency response, and protection.
Advises on amplifier location, ensuring airflow, and proper mounting using screws, avoiding vehicle lines.
Details using appropriate gauge wires, connecting to the battery, fuse placement, and secure grounding to bare metal.
Explains using quality RCA cables, routing them away from power wires, and connecting hi-level inputs using speaker wire.
Adjusts input sensitivity for proper matching and safe operation, preventing distortion.
Explains filter type (LPF, FULL, HPF) and frequency adjustment for tailoring sound.
Describes using the low-level output for connecting to another amplifier without fading.
Details the function and importance of the subsonic filter for subwoofer protection and efficiency.
Explains configuring two T2-5001 amplifiers for increased output in a Master/Slave setup.
Details protection circuits (short, overload, voltage, thermal) and status LEDs (NORMAL, PROTECT).
Advises on appropriate fuse ratings for the T2-5001 based on impedance and configuration.
Provides continuous and maximum power ratings for 4-ohm and 2-ohm loads across models.
Lists THD, Signal to Noise Ratio, and Frequency Response for each amplifier model.
Details crossover capabilities (HPF, LPF) and input sensitivity ranges for all models.
Includes speaker impedance, damping factor, dimensions, and fuse rating information.
Illustrates how to connect the source unit's signal output to the T2-Series amplifiers.
Shows wiring configurations for the T2-602 in 2-channel and bridged modes.
Shows wiring configurations for the T2-604 in 4-channel and 3-channel modes.
Illustrates wiring for the T2-5001 in 1-woofer and 2-woofer configurations.
Details the wiring setup for connecting two T2-5001 amplifiers in a Master/Slave configuration.
To Next Page
General
