Set up:
1. Attach the QD bracket to the picatinny rail on your firearm. You may need to adjust the tension using a 2.5mm
allen wrench. Set the tension as tight as possible, while still allowing the lever to be released using your fingers.
2. Next, place the barrel spacers you normally use on your V3, and hold the unit in place on your barrel as you
would if using the V3 mfg supplied retention strap.
3. Ensure there is no interference with either “ball end”.
4. Tighten the tension handle, ensuring that the teeth at the hub mesh completely. Tighten only enough to hold
the assembly in place for now.
To Next Page
Loading...