Ulvac HELIOT 900 - Safety Symbols; Prior to Use

Prior to Use
- I -
Safety Symbols
The following safety symbols are used in order for the operator to understand items which must be
observed in this operations manual and the equipment’s warning notices. The language used in the
symbols is classified as follows.
This symbol indicates the imminent possibility of death or series injury to the
operator if the equipment is incorrectly used.
If the work is carried out disregarding this warning, there will be a
possibility of
serious damage to human life or to the manufacturing facility (including this
equipment).
This symbol indicates the possibility of death or series injury to the operator of the
equipment if it is incorrectly used.
If the work is carried out disregarding this warning, there will be a possibility of
damage to human life or to the manufacturing facility (including this equipment).
This symbol indicates the possibility of the operator receiving a moderate injury
or serious damage to the equipment or possibility of incorrect operation if the
equipment is incorrectly used.
Prior to Use
Thank you for purchasing our ULVAC equipment. On receipt of the equipment, please verify that the
model ordered is correct and check for any damages caused during shipment.
Read this manual before installing, operating, inspecting or maintenance of the
equipment and fully understand the safety precautions, specifications, and
operating procedures regarding the equipment.
When unpacking or moving the equipment, do not incline more than 30 degrees.
Maintain a horizontal position during installation.
Failure to do so may result in oil leaks or damage to the equipment.
The copyright of this operations manual is held by ULVAC, Inc.
No portion of this manual may be reproduced without acceptance of ULVAC
, Inc.
Also, it is
prohibited to disclose or transfer this operations manual to any third
parties without the written consent of ULVAC, Inc.
Please note that the information within
this operations manual is subject to
change without any notice for changes in specifications and modifications of the
equipment.