Service Manual UPO1000X Series
Instruments.uni-trend.com
4. If you want to reinstall the rear panel, execute the steps in reverse. Use T8 quincunx screwdriver to fix the screw.
Remove Rear Mdule
The following process is describes the removal and replacement of rear module.
Precondition
• To prevent static damage to the components while working on the instrument, wear properly grounded anti-static
wristbands and foot bands, and use anti-static pads in a tested anti-static environment.
• Take down the rear panel.
Steps
1. Use T10 quincunx screwdriver to move M3 screws on the top side.
To Next Page
Loading...
