Need help?Do you have a question about the UNI-T UT528AU and is the answer not in the manual?
General| Display | LCD |
|---|---|
| Resistance Measurement | Yes |
| Capacitance Measurement | No |
| Frequency Measurement | No |
| Data Hold | Yes |
| Backlight | Yes |
| Battery | 6x 1.5V AA batteries |
| Ground Voltage Measurement Range | 0 to 200V AC |
| Display Count | 2000 |
| Double Insulation Protection | Yes |
| Low Battery Indication | Yes |
| Data Logging | No |
| USB Interface | No |
| Over Range Indication | Yes |
| Simple 2-Wire Testing | Yes |
| Precise 3-Wire Testing | Yes |
| Power Supply | 6x 1.5V AA batteries |
| Weight | Approx. 500g |
| Type | Ground Resistance Tester |
| Ground Resistance Measurement Range | 0.01Ω to 2000Ω |
| Accuracy of Ground Voltage Measurement | ±(1%+3) |
| Measurement Range | 0.00Ω to 2000Ω |
| Accuracy | ±2% ±0.01Ω |
| Accuracy of Ground Resistance Measurement | ±(2%+3) |
Advises inspecting unit/leads, battery replacement, and environmental conditions for safe operation.
Describes the procedure to zero the earth bond test lead using a nulling adapter.
Details appliance connection and earth clip placement for Class 1 testing.
Explains initiating the earth resistance test using the Class 1 test button.
Explains how to interpret FAIL and PASS results for earth bond tests.
Details the insulation test, including auto-start, manual trigger, and results.
Explains the automatic progression to and interpretation of leakage tests.
Details appliance connection for Class 2 testing as shown in Diagram 4.
Details the insulation test for Class 2, including power switch checks.
Explains Class 2 leakage test progression, interpretation, and results.
Details connecting mains leads for testing as shown in Diagram 5.
Describes performing the earth bond test for cords, similar to Class 1.
To Next Page
