Need help?Do you have a question about the UNI-T UTD2102CL+ and is the answer not in the manual?
General| Bandwidth | 100 MHz |
|---|---|
| Sample Rate | 1 GSa/s |
| Channels | 2 |
| Display | 7 inch TFT LCD |
| Interfaces | USB Host, USB Device |
| Power Supply | 100-240 V AC, 50/60 Hz |
| Max Input Voltage | 400 V (DC + AC Peak) |
| Math Functions | +, -, ×, ÷, FFT |
| Memory Depth | 25 kpts |
| Record Length | 25k points |
| Display Resolution | 800 x 480 pixels |
| Input Impedance | 1 MΩ ± 2%, in parallel with 20 pF ± 3 pF |
| Vertical Sensitivity | 2 mV/div to 5 V/div |
| Timebase Range | 2 ns/div to 50 s/div |
| Trigger Types | Edge, Pulse, Video, Slope |
| Vertical Resolution | 8 bit |
| Waveform Capture Rate | up to 2000 wfms/s |
| Storage Depth | 25k points |
| Probe Attenuation | 1X, 10X |
Important safety measures for operating the oscilloscope.
Steps to inspect the instrument for damages after purchase.
Procedure to verify the instrument's operational status.
Configuration of coupling, bandwidth, and probe settings.
Overview of trigger controls and common trigger types.
Selecting and configuring measurement parameters.
Configuring cursor measurement types, modes, and units.
Practical steps for measuring time and voltage with cursors.
Demonstrations of measuring signals and delays.
Techniques for reducing noise and using cursors for measurements.
Solutions for common issues like no waveform or trigger problems.
Detailed technical specs for Acquire, Input, Horizontal, Vertical, and Trigger systems.
To Next Page