Need help?Do you have a question about the UNI-T UTD2202CE and is the answer not in the manual?
General| Bandwidth | 200 MHz |
|---|---|
| Sample Rate | 1 GSa/s |
| Channels | 2 |
| Display | 7 inch TFT LCD |
| Timebase Range | 5 ns/div to 50 s/div |
| Display Resolution | 800 x 480 |
| Input Impedance | 1 MΩ ± 2% |
| Vertical Sensitivity | 1 mV/div to 10 V/div |
| Trigger Modes | Edge, Pulse, Video |
| Interfaces | USB Host, USB Device |
| Math Functions | Add, Subtract, Multiply, FFT |
| Power Supply | 100-240 VAC, 50/60 Hz |
Instructions for initial inspection of the digital storage oscillograph upon receipt.
Procedure for performing a quick functional check of the oscillograph's operation.
Guides on how to adjust probe compensation for accurate measurements.
Explains how to use the automatic setup function for optimal waveform display.
Covers setting up vertical systems including CH1, CH2, MATH, REF, OFF, VERTICAL POSITION, and VERTICAL SCALE.
Details setting up horizontal systems including MENU, HOR MENU, HORIZONTAL POSITION, and HORIZONTAL SCALE.
Explains setup of trigger systems including TRIGGER LEVEL, MENU, 50%, and FORCE.
Covers setting the sampling mode using the ACQUIRE function.
Details how to set the display mode using the DISPLAY function.
Explains how to store and recall waveforms, setups, and bitmaps.
Explains prompts related to regulation, U-disk connection, and saving operations.
Provides steps to diagnose and resolve issues like no display or unstable waveforms.
To Next Page