Need help?Do you have a question about the UNI-T UTD2052CL+ and is the answer not in the manual?
General| Bandwidth | 50 MHz |
|---|---|
| Sample Rate | 500 MSa/s |
| Channels | 2 |
| Trigger Modes | Edge, Pulse, Video, Alternate |
| Rise Time | ≤ 7 ns |
| Time Base Range | 5 ns/div to 50 s/div |
| Display Resolution | 800 x 480 |
| Weight | 2.2 kg |
| Display Size | 7 inch |
| Display Type | TFT LCD |
| Input Impedance | 1 MΩ ± 2% |
| Interfaces | USB Host, USB Device |
| Power | 100-240 VAC, 50/60 Hz |
Procedures for inspecting the instrument after purchase.
Steps to verify the oscilloscope's operational status.
Identification and description of the instrument's front and rear panels.
How to set the coupling mode (AC, DC, GND) for input channels.
How to enable or disable bandwidth limiting for channels.
Adjusting the vertical scale (Volts/Div) for signal amplitude.
Using knobs to control horizontal time base and position.
Triggering based on the rising or falling edge of a signal.
Triggering based on the duration of a pulse.
Triggering based on the slew rate of a signal edge.
Setting a waiting time before the next trigger event.
Solutions for common problems like no waveform, no trigger, or slow refresh.
Technical specifications for the DSO's acquisition system.
Technical specifications related to input channels.
Technical specifications for the horizontal system.
To Next Page