Need help?Do you have a question about the UNI-T UTG9000C-II Series and is the answer not in the manual?
General| Brand | UNI-T |
|---|---|
| Model | UTG9000C-II Series |
| Category | Portable Generator |
| Language | English |
Defines warning terms and symbols used in the manual and on the product for hazard identification.
Provides essential safety precautions and compliance standards for operating the instrument safely.
Covers instrument settings like output impedance, screen brightness, and factory reset.
Details the procedure to restore the instrument to its original factory default settings.
Introduces amplitude (AM) and frequency (FM) modulation capabilities for waveform generation.
Guides on setting up and utilizing Amplitude Modulation (AM) with carrier and modulation signals.
Provides a step-by-step example for configuring and outputting an AM modulated waveform.
Details how to set up and utilize Frequency Modulation (FM) with carrier and modulation signals.
Provides a step-by-step example for configuring and outputting an FM modulated waveform.
Introduces the frequency sweep function and its modes for outputting signals across a frequency range.
Guides on enabling and selecting the frequency sweep mode (Logarithmic or Linear).
How to configure the start and stop frequencies for the frequency sweep operation.
Troubleshooting steps for when the instrument screen remains blank upon power-on.
Steps to resolve issues where no waveform is output despite correct settings.
To Next Page
