UNI-T UTG900E Series - Page 21

LINI-T,.
3) Set Waveform and Parameter of Carrier Wave Signal
Press |Wave| >| Sine |to select sine wave (default) as carrier waveform.
Press [Freq/ to set frequency, enter 900 by numeric keypad, and select parameter unit [Hz].
Press [Amp |to set amplitude, enter 100, and select parameter unit [mVpp).
As the picture shown:
0 my
4) Set Phase Deviation
After setting the carrier wave parameters, press [Mode [PM] to enable PM function.
Press |PhaseDev) and enter 200, select parameter unit [°].
21