What to do if Unibor E100 Drill is used on plate and sheet steel exceeding 850N/mm² hardness?
When using your Unibor Drill on plate and sheet steel exceeding 850N/mm² hardness, it's recommended to use an M42 cutter.
What cutter is recommended for cast iron exceeding 700N/mm² hardness with Unibor E100?
If you're drilling cast iron exceeding 700N/mm² hardness with your Unibor Drill, use an M2 cutter.
What type of cutter is recommended for brass exceeding 700N/mm² hardness with Unibor E100?
When using your Unibor Drill on brass exceeding 700N/mm² hardness, it's recommended to use an M42 cutter.
What cutter should I use for aluminum exceeding 750Nmm² hardness with Unibor E100?
If you're using your Unibor Drill on aluminum exceeding 750Nmm² hardness, it's recommended to use an M42 cutter.
What cutter to use for plate and sheet steel exceeding 700N/mm² hardness with Unibor E100?
If you're using your Unibor Drill on plate and sheet steel exceeding 700N/mm² hardness, consider using an M42 cutter.
What cutter should I use for steel angle and joists exceeding 700N/mm² hardness with Unibor E100 Drill?
When using your Unibor Drill on steel angles and joists exceeding 700N/mm² hardness, it's recommended to use an M42 cutter.
What cutter to use for mild and free cutting steels exceeding 700N/mm² hardness with Unibor E100 Drill?
For mild and free cutting steels exceeding 700N/mm² hardness when using your Unibor Drill, use an M42 cutter.
What cutter is best for brass exceeding 850N/mm² hardness with Unibor E100 Drill?
When drilling brass exceeding 850N/mm² hardness with your Unibor Drill, consider using an M42 cutter.
Which cutter should I use for aluminum exceeding 850N/mm² hardness with Unibor E100 Drill?
If you are using your Unibor Drill on aluminum exceeding 850N/mm² hardness, it's recommended to use an M42 cutter.
What to do if my Unibor E100 Drill is used on stainless steel exceeding 850N/mm² hardness?
If you're using your Unibor Drill on stainless steel that exceeds 850N/mm² hardness, consider using a TCT cutter.
Guidelines for maintaining a clean, well-lit work area and avoiding hazardous environments.
Precautions for safe use of electrical power, including grounding and cord care.
Instructions for operator alertness, appropriate attire, and use of safety equipment.
General| Brand | Unibor |
|---|---|
| Model | E100 |
| Type | Magnetic Drill |
| Cutter Capacity | 100 mm |
| Tapping Capacity | M30 |
| Countersinking Capacity | 50 mm |
| Arbor | 3/4" Weldon |
To Next Page
