8.14 Voice message list
Remote control ready When PTO is connected, and the crane power supply is turned on
When turned into normal mode by pushing the radio control selector switch.
When the emergency stop is released by pushing the emergency stop switch.
State that switch is not pushed State that switch is pushed
Emergency stop is released Emergency stop
Secure lifting hook When the Hook store switch is operated.
Service remote control When the mode display blinks one of 【 42-58 】and【 60-87 】.
Low transmitter battery When the battery of the transmitter has been run out.
Stop winch up
When any of raising boom,winding up hook,and extending boom is operated
during over-wound condition.
When changeed to the low temperature operation mode.
When the low temperature operation mode has been released.
Change control mode
Radio control
selector switch
( 8 - 15 )
To Next Page
