Unic URW295CUR - Engine Start;Stop with Radio Controller

TRAVEL LEVER STAND
LOCK LEVER
STAND LEVER
TRAVEL LEVER
CRANE OPERATION POSITION TRAVEL POSITION STOWAGE POSITION
7.8 Method of engine start and stop that uses radio controller
However, this operation is possible under the following condition.
１） Starter switch on.
２） Shift the travel lever to “CRANE OPERATION.” position.
３）
Push the mode selector switch to switch it to the radio remote control mode.
The
Mode indicator lamp lights on.
４） Key switch on.
Depress the switch for mode select with
the switch for slewing C.C.W.turned ON.
Depress the switch for mode select with
the switch for slewing C.W.turned ON.
Engine stop Engine start
（７－6）
Courtesy of Machine.Market