Mode Mode description
Radio
control
operation
mode
Manual
operation
mode
Priority
Current control is on low temperature operation mode.
Operation can be carried by manual control but not
through radio remote control.
×
◯
8
Hook hits against weight for over-winding alarm
(over-wound condition).
― ―
7
During operation of storing hook.
― ―
6
Automatic stop for over-winding reset switch is being
controlled
― ―
4
Outriggers fail to touch the ground or overturn thresh-
old alarm is actuated (URW series only).
― ―
2
Outriggers fail to be set up on the ground securely or
overturn prediction alarm is actuated (URW series
only).
― ―
3
●
Remarks
Since priority is assigned for each mode description, it is to be indicated in the order of higher
priority.
If the [.] (dot) is indicated on the bottom right of mode indicator lamp, it means the radio
control OFF mode.
Crane cannot be operated through radio control transmitter.
When operated on outrigger radio control mode, crane operation other than extension/retraction
of outriggers cannot be carried out.
When the shock-less function has been cancelled, the letter on the left indicated in the mode
indicator changes to [ ].
-
To Next Page
Loading...
