(Normal Operation)
Outdoor Unit (ODU) has power
(Normal Operation)
Outdoor Unit (ODU) has power. Indoor units ready to run.
(Factory Test Mode) (DL1 blinks)
Remove jumper JP1 on ODU Main PCB to resume normal operation
Unit is being programmed, or Firmware is faulty
Communication fault with indoor unit(s)
PFC (Power factor controller) fault
Outdoor fan power module temperature too high
Compressor power module temperature too high
Compressor current too high
OCT (Outdoor Coil Temperature) probe sensor fault
OAT (Outdoor Air Temperature) probe sensor fault
CDT (Compressor Discharge Temperature) probe sensor fault
CTS (Compressor Top Shell) probe sensor fault
Invalid Indoor-Outdoor Unit Combination
*
Error #0 = Lowest priority. If more than one error is present, only
the highest priority error is shown.
WTT = Wide Tube Temperature = Suction line in cooling mode.
NTT = Narrow Tube Temperature = Liquid line in cooling mode.
= Solid
= Blinking
= Off